#include <LOLIN_HP303B.h>

// HP303B Opject
LOLIN_HP303B HP303BPressureSensor;


void setup()
{
  Serial.begin(115200);
  while (!Serial);


  //Call begin to initialize HP303BPressureSensor
  //The parameter 0x76 is the bus address. The default address is 0x77 and does not need to be given.
  //HP303BPressureSensor.begin(Wire, 0x76);
  //Use the commented line below instead of the one above to use the default I2C address.
  //if you are using the Pressure 3 click Board, you need 0x76
  HP303BPressureSensor.begin();

  Serial.println("Init complete!");
}



void loop()
{
  int32_t temperature;
  int32_t pressure;
  int16_t oversampling = 7;
  int16_t ret;
  Serial.println();

  //lets the HP303B perform a Single temperature measurement with the last (or standard) configuration
  //The result will be written to the paramerter temperature
  //ret = HP303BPressureSensor.measureTempOnce(temperature);
  //the commented line below does exactly the same as the one above, but you can also config the precision
  //oversampling can be a value from 0 to 7
  //the HP303B will perform 2^oversampling internal temperature measurements and combine them to one result with higher precision
  //measurements with higher precision take more time, consult datasheet for more information
  ret = HP303BPressureSensor.measureTempOnce(temperature, oversampling);

  if (ret != 0)
  {
    //Something went wrong.
    //Look at the library code for more information about return codes
    Serial.print("FAIL! ret = ");
    Serial.println(ret);
  }
  else
  {
    Serial.print("Temperature: ");
    Serial.print(temperature);
    Serial.println(" degrees of Celsius");
  }

  //Pressure measurement behaves like temperature measurement
  //ret = HP303BPressureSensor.measurePressureOnce(pressure);
  ret = HP303BPressureSensor.measurePressureOnce(pressure, oversampling);
  if (ret != 0)
  {
    //Something went wrong.
    //Look at the library code for more information about return codes
    Serial.print("FAIL! ret = ");
    Serial.println(ret);
  }
  else
  {
    Serial.print("Pressure: ");
    Serial.print(pressure);
    Serial.println(" Pascal");
  }

  //Wait some time
  delay(500);
}