68 lines
2.0 KiB
C++
68 lines
2.0 KiB
C++
/***************************************************
|
|
This is an example sketch for our optical Fingerprint sensor
|
|
Designed specifically to work with the Adafruit Fingerprint sensor
|
|
----> http://www.adafruit.com/products/751
|
|
These displays use TTL Serial to communicate, 2 pins are required to
|
|
interface
|
|
Adafruit invests time and resources providing this open source code,
|
|
please support Adafruit and open-source hardware by purchasing
|
|
products from Adafruit!
|
|
Written by Limor Fried/Ladyada for Adafruit Industries.
|
|
BSD license, all text above must be included in any redistribution
|
|
****************************************************/
|
|
|
|
#include <Adafruit_Fingerprint.h>
|
|
|
|
|
|
#if (defined(__AVR__) || defined(ESP8266)) && !defined(__AVR_ATmega2560__)
|
|
// For UNO and others without hardware serial, we must use software serial...
|
|
// pin #2 is IN from sensor (GREEN wire)
|
|
// pin #3 is OUT from arduino (WHITE wire)
|
|
// Set up the serial port to use softwareserial..
|
|
SoftwareSerial mySerial(2, 3);
|
|
|
|
#else
|
|
// On Leonardo/M0/etc, others with hardware serial, use hardware serial!
|
|
// #0 is green wire, #1 is white
|
|
#define mySerial Serial1
|
|
|
|
#endif
|
|
|
|
// Using sensor without password
|
|
Adafruit_Fingerprint finger = Adafruit_Fingerprint(&mySerial);
|
|
|
|
// Using sensor with password
|
|
//Adafruit_Fingerprint finger = Adafruit_Fingerprint(&mySerial, 1337);
|
|
|
|
void setup()
|
|
{
|
|
while (!Serial); // For Yun/Leo/Micro/Zero/...
|
|
|
|
Serial.begin(9600);
|
|
Serial.println("Adafruit fingerprint sensor, change password example");
|
|
|
|
// set the data rate for the sensor serial port
|
|
finger.begin(19200);
|
|
|
|
if (finger.verifyPassword()) {
|
|
Serial.println("Found fingerprint sensor!");
|
|
} else {
|
|
Serial.println("Did not find fingerprint sensor :(");
|
|
while (1);
|
|
}
|
|
|
|
Serial.print("Set password... ");
|
|
uint8_t p = finger.setPassword(1337);
|
|
if (p == FINGERPRINT_OK) {
|
|
Serial.println("OK"); // Password is set
|
|
} else {
|
|
Serial.println("ERROR"); // Failed to set password
|
|
}
|
|
}
|
|
|
|
void loop()
|
|
{
|
|
|
|
}
|
|
|